Connect


X Switch




8.1 X Switch: Cross connection from an analog to a digital objects.






xSwitch



Cross connection from an analog to a digital objects.
Read the value from an object (i.e. sensor) and switch on or off the output according to the read value.
To avoid rapid switch events when the read value is very close to the switch level, a hysteresis can be applied.




Properties:


Property Description Range Default
name Name of the cross connect service - -
switchLevel Level for trigger switch.
The output is actived when the input is over the switch level value. The output is deactived when the input is below the switch level value.
This value can be set to any values in the range of the input device.
- 0.5
hysteresis Trigger hysteresis amplitude.
It is expressed absolute units of value.
It can be used to compensate for contact bounce in bad quality switches (a minimum bounce is already handled by Dome without the need of a hysteresis) or to avoid rapid switch events when the read value is very close to the switch level.
- 0.02
negate Set the output active low Yes/No No
displayshow Show in local display if any Yes/No No
descr description of cross connection - -


Top

<< Index >>