Comm


Wifi_mod




1.1 Wifi_mod: Adafruit WI-FI breakout based on TI CC3000 It is recommended to use this shield on Arduino Mega or higher. Arduino Uno or similar size could not have enough memory to host your application.






wifi_mod



Adafruit WI-FI breakout based on TI CC3000 It is recommended to use this shield on Arduino Mega or higher. Arduino Uno or similar size could not have enough memory to host your application.




Properties:


Property Description Range Default
name Name of the wi-fi device - -
mac MAC address of the device. It is a sequence of six hexadecimal values (like '0xNN' where N is 0-9 or A-F) separed by a comma. The sequence of these values must be unique in your local network (theoretically in the world). So if you have more controllers attached to your local network, you must change the sequences and make them different each other, otherwise nothing works any more. - 0xD4, 0xFF, 0x76, 0x44, 0x55, 0x44
ssid Network SSID. - -
passw Network password. - -
security Type of Ethernet device UNSEC
WEP
WPA
WPA2
WPA2
irq IRQ pin - To Be Correctly Autoassigned!!!!!!!! - -
sdce CE pin for SD card - -
vbat_en Power enable pin - -
ethce CE pin for WI-FI - -
light Ready led pin number. The ready led will switch on when the WiFi module is connected to the AP and ready to work. Leave it empty if you don't want a Rx led. - -
descr description of Ethernet device - -
static When the static box is not checked, the system configures the IP properties automatically through the DHCP. That means that the values are automatically reassigned, and could change, every time the DHCP restart its procedure. When the static box is checked, you need to configure all the following ip, gw, dns and mask properties and they will never change untill you chenge them again, as they are defined as static. Yes/No No
ip IP address - 192.168.1.10
gw default gateway address - 192.168.1.1
dns DNS address - 192.168.1.2
mask network mask - 255.255.255.0


Top

Index >>